Abstract :
Now a days the processing of natural Fibre reinforced polymer composite through microwave curing going on a fortunate steps for better properties. It has been observed that the application of NFRPC is increasing day to day. Due to their low cost and light weight that type of composite is applying at various light load capacity areas. Processing of NFRPC depends on a large no factors. Due to practical constraint 3 domen parameters were considered during experimental investigation. The value of the parameter were selected on the basis of material characteristics and experimental available in the Laboratory. Design of Experiment were used for planning the experiments. Optimum process parameter were determined for improvement ultimate tensile strength. The selection of optimum parameter was assured by mechanical testing as well as microscopic structure. Processing of composite by using optimized parameters resulted in improvement in tensile strength by 3 . The ANOVA table was prepared and table was shown Curing Time is one of the main crucial parameter which affects the composite processing. Shubham Singh | Jitendra Sharma | Ujjwaldeep | Krishna Gupta | Manabendra Saha "Development and Optimization of Process Parameters of Microwaved Cured Polymer Based Natural Fibre (Coir) Reinforced Composite" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-4 , June 2019, URL: https://www.ijtsrd.com/papers/ijtsrd23595.pdf Paper URL: https://www.ijtsrd.com/engineering/mechanical-engineering/23595/development-and-optimization-of-process-parameters-of-microwaved-cured-polymer-based-natural-fibre-coir-reinforced-composite/shubham-singh
Keyword :
Scientific research, challenges, literature review