Abstract :
This paper presents on optimizing the end milling process parameters based on the Taguchi method to minimize surface roughness and Tool wear for the work piece of Al 6063 alloy with high speed steel. The input parameters are speed rpm , feed rate mm min and depth of cut mm . S N ratio is calculated by using Taguchi method under the L9 orthogonal array OA with 3 factor and 3 levels. This S N ratio is analysed by analysis of variance ANOVA ,and also find out the effects of control factor with help of analysis of variance. Finally, Results shown that, Taguchi design is the significant method to optimizing the milling process parameters of Speed 1200 rpm with 20 Significant. Arun K K | Ponnuswamy D "Optimization of Dry End Milling Process Parameters of Al-6063 Alloy Using Taguchi Method" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-2 | Issue-3 , April 2018, URL: https://www.ijtsrd.com/papers/ijtsrd11643.pdf Paper URL: http://www.ijtsrd.com/engineering/mechanical-engineering/11643/optimization-of-dry-end-milling-process-parameters-of-al-6063-alloy-using-taguchi-method/arun-k-k
Keyword :
ANOVA, End Milling, Surface roughness, Taguchi Method